Fujitsu ETERNUS DX100 S3 - Drive Enclosure; Figure 114 Host Interface Installation Diagram (When Two Controllers Are Installed in the ETERNUS DX200 S4;DX200 S3)

● Installation Order for the
ETERNUS DX200 S4/DX200 S3
Install the host interfaces in CA#0 first, and then install CA#1.
The configuration is the same for Controller 0 (CM#0) and Controller 1 (CM#1).
Figure 114 Host Interface Installation Diagram (When Two Controllers Are Installed in the ETERNUS
DX200 S4/DX200 S3)
Controller 0 (CM#0) Controller 1 (CM#1)
Port
#0
Por
t
#1
CA#1
Port
#0
Por
t
#1
CA#0
Port
#0
Por
t
#1
CA#1
Port
#0
Por
t
#1
CA#0
Expansion Expansion
R
ear view of the controller enclosure
Drive Enclosure
This section describes the installation order for drive enclosures.
2.5" type, 3.5" type, and high-density drive enclosures can be installed together in the
ETERNUS
DX.
Drive enclosures can connect with other enclosures even if drives are not installed.
The installation priority order for drive enclosures varies depending on the controller enclosure
type.
■
2.5" Type Controller Enclosure
1 High-density drive enclosures (12Gbit/s)
2 High-density drive enclosures (6Gbit/s)
3 2.5" type drive enclosures
4 3.5" type drive enclosures
■
3.5" Type Controller Enclosure
1 High-density drive enclosures (12Gbit/s)
2 High-density drive enclosures (6Gbit/s)
3 3.5" type drive enclosures
4 2.5" type drive enclosures
Drive enclosures are installed above the controller enclosure according to the priority order.
5. Hardware Configurations
Standard Installation Rules
187
Fujitsu Storage ETERNUS DX100 S4/DX200 S4, ETERNUS DX100 S3/DX200 S3 Hybrid Storage Systems
Design Guide (Basic)
Copyright 2023 Fujitsu Limited
P3AM-7642-32ENZ0