Fujitsu Eternus DX600 S3 - Page 1010

Appendix B Factory Default List
B.6 Advanced Copy Management
ETERNUS Web GUI User’s Guide (Settings)
Copyright 2015 FUJITSU LIMITED P2X0-1270-13ENZ0
1010
■ Modify Copy Table Size
■ Modify Copy Parameters
■ Set Copy Path
Screen Setting item Default value
Advanced Copy Table Size
Setting
Resolution
• For the ETERNUS DX60 S3/DX100 S3/DX200 S3
x 16
• For the ETERNUS DX500 S3/DX600 S3
x 1
• For the ETERNUS DX8700 S3/DX8900 S3
x 1
• For the ETERNUS DX200F
x 16
Table Size
• For the ETERNUS DX60 S3/DX100 S3/DX200 S3
128 (MB)
• For the ETERNUS DX500 S3/DX600 S3
0
• For the ETERNUS DX8900 S3/DX8700 S3
0
• For the ETERNUS DX200F
128 (MB)
Table Size Threshold 80 (%)
Screen Setting item Default value
Policy of Snap Data Pool Policy Level 1 (Informational)
Threshold
50 (%)
Policy Level 2 (Warning)
Threshold
70 (%)
Policy Level 3 (Error) Threshold 99 (%)
SDPE Setting SDPE 1 (GB)
Screen Setting item Default value
Operation Mode Selection Operation Mode Create Copy Path
Base Information Selection Base Information Backup Path File
Storage System Configuration
Settings
Initiator/Target Setting
(for ETERNUS6000)
Initiator
Port Settings WWN FC port WWN
IP Version IPv4
IP Address Not specified
IPv6 Link Local Address Not specified
IPv6 Connect IP Address Not specified