Chapter 1 System Management
1.8 Network Management
ETERNUS Web GUI User’s Guide (Settings)
Copyright 2015 FUJITSU LIMITED P2X0-1270-13ENZ0
111
5 Click the [Done] button to return to the [Network] screen.
1.8.3 Setup SNMP Agent Basic Interface
This function sets up the SNMP Agent basic interface in the ETERNUS DX.
SNMP is a standard protocol used for network management.
For details on the parameters for this function, refer to "A.1.7.3 Setup SNMP Agent Basic Interface" (page
710).
For the factory default settings for this function, refer to "Appendix B Setup SNMP Agent Basic Interface" (page
980).
• When SNMP Manager exists in a different subnetwork from where the ETERNUS DX belongs, specify the IP
address or the network address of SNMP Manager in "Allowable IP Address" using the procedure in "1.8.1
Setup Network Environment" (page 97).
• Before enabling the SNMP function, use the procedure in "1.8.2 Setup Firewall" (page 109)
to allow the
"SNMP" for the setting target LAN port.
• By using "1.1 Initial Setup" (page 27), the SNMP Agent environment can be configured with the wizard.
Refer to "Initial Setup" in "FUJITSU Storage ETERNUS DX Configuration Guide (Web GUI)". When the [Initial
Setup] function is not used, configure the SNMP Agent environment in the following order:
- When using SNMPv1 or SNMPv2c for SNMP communication
(1)Setup SNMP Agent Basic Interface
(2)Setup SNMP Manager
(3)Setup SNMP Agent MIB Access View
(4)Setup SNMP Agent Community
(5)Setup SNMP Agent Trap
- When using SNMPv3 for SNMP communication
(1)Setup SNMP Agent Basic Interface
(2)Setup SNMP Manager
(3)Setup SNMP Agent MIB Access View
(4)Setup SNMP Agent User
(5)Setup SNMP Agent Trap
• The parameter settings specified using this function remain even when the "SNMP Function" setting is
changed from "Enable" to "Disable".
To Next Page
Loading...
