Fujitsu Eternus DX600 S3 - Stop Host-LU Qos Performance Monitoring

Chapter 4 Connectivity Management
4.7 Host-LU QoS Management
ETERNUS Web GUI User’s Guide (Settings)
Copyright 2015 FUJITSU LIMITED P2X0-1270-13ENZ0
487
3 Click the [Done] button to return to the [Host-LU QoS] screen.
End of procedure
■ When this function is selected in the [Port QoS] screen for each host interface
Procedure
1 Select the port to start the Host-LU QoS performance monitoring for (multiple selections can
be made) and click [Start Perfmon] in [Action].
 A confirmation screen appears.
2 Click the [OK] button.
 Acquisition of Host-LU QoS performance information starts.
3 Click the [Done] button to return to the screen when starting this function in Step 1.
End of procedure
4.7.6 Stop Host-LU QoS Performance Monitoring
This function stops performance monitoring of Host-LU QoS.
The procedure to stop the Host-LU QoS performance monitoring is as follows:
■ When this function is selected in the [Host-LU QoS] screen
Procedure
1 Click [Stop Perfmon] in [Action].
 A confirmation screen appears.
When this function is started after port selection, ports with different host interfaces cannot be selected at
the same time.