Fujitsu Eternus DX600 S3 - Connectivity Management; B.3 Connectivity Management

Appendix B Factory Default List
B.3 Connectivity Management
ETERNUS Web GUI User’s Guide (Settings)
Copyright 2015 FUJITSU LIMITED P2X0-1270-13ENZ0
992
B.3 Connectivity Management
This section provides information on the default parameters of the following actions for connectivity
management.
• Create Host Affinity
• Add FC/FCoE Host Group
• Add iSCSI Host Group
• Add SAS Host Group
• Add FC/FCoE Host
• Add iSCSI Host
• Add SAS Host
• Modify FC Port Parameters (when the port mode is "CA")
• Modify FC Port Parameters (when the port mode is "RA" or "CA/RA")
• Modify FC Port Parameters (when the port mode is "Initiator")
• Modify iSCSI Port Parameters (when the port mode is "CA")
• Modify iSCSI Port Parameters (when the port mode is "RA")
• Modify iSCSI Port Parameters (when the port mode is "CA/RA")
• Modify iSCSI Port Parameters (when the port type is "iSCSI RA (for older storage system connection)")
• Modify iSCSI Port Parameters ([Send Ping] screen)
• Modify SAS Port Parameters
• Modify FCoE Port Parameters
• Modify Port Mode
• Add LUN Group
• Add Host Response
• Modify CA Reset Group
• QoS
• Set FC/FCoE Host QoS
• Set iSCSI Host QoS
• Set SAS Host QoS
• Set FC Port QoS
• Set iSCSI Port QoS
• Set SAS Port QoS
• Set FCoE Port QoS
• Add LU QoS Group
• Create Shared Folder
• Create NAS Interface
• Change NAS Server Name
• Add Quota Setting