Fujitsu Eternus DX600 S3 - Page 996

Appendix B Factory Default List
B.3 Connectivity Management
ETERNUS Web GUI User’s Guide (Settings)
Copyright 2015 FUJITSU LIMITED P2X0-1270-13ENZ0
996
*1: The default value varies depending on the factory setting. Refer to "The default value for "iSCSI Name"" (page 1003)
for details.
■ Modify iSCSI Port Parameters (when the port mode is "RA")
*1: The default value varies depending on the factory setting. Refer to "The default value for "iSCSI Name"" (page 1003)
for details.
Additional IP Address Settings Multiple VLAN Disable
IP Address Not specified
Subnet Mask Not specified
Gateway Not specified
IPv6 Link Local Address Not specified
IPv6 Connect IP Address Not specified
IPv6 Gateway Not specified
Screen Setting item Default value
Screen Setting item Default value
iSCSI Settings iSCSI Name iqn.2000-09.com.fujitsu:storage-system.eternus-
xxxx:00yyyyyy (*1)
TCP/IP Settings IP Version IPv4
IP Address 192.168.xxx.xxx
Subnet Mask 255.255.255.0
Gateway Not specified
IPv6 Link Local Address Address that is obtained from the WWN of the
ETERNUS DX
IPv6 Connect IP Address Not specified
IPv6 Gateway Not specified
TCP Port No. 3260
TCP Window Scale 2
VLAN ID
• Disable
• When the "Enable" checkbox is selected
0
MTU 1300 bytes
Security Setting CHAP OFF
REC Settings REC Line No. 0
REC Transfer Mode
Sync (synchronous transfer
mode)
Enable
Async Stack (asynchronous
stack mode)
Async Consistency
(asynchronous consistency
mode)
Async Through
(asynchronous through
mode)