Fujitsu Eternus DX600 S3 - A.7.3 Modify Copy Table Size

Appendix A Parameter List
A.7 Advanced Copy Management
ETERNUS Web GUI User’s Guide (Settings)
Copyright 2015 FUJITSU LIMITED P2X0-1270-13ENZ0
938
A.7.3 Modify Copy Table Size
For details about this function, refer to "7.6 Modify Copy Table Size" (page 602).
For the factory default settings for this function, refer to "Appendix B Modify Copy Table Size" (page 1010)
.
● Advanced Copy Table Size Setting
• Resolution
• Table Size
Description Select the resolution for the copy table.
Input condition/
Display contents
• x 1
• x 2
• x 4
• x 8
• x 16
• x 32
• x 64
Description Select the copy table size.
The maximum size that can be specified is an estimated value that is calculated from the
memory capacity in the ETERNUS DX and the amount of memory allocation for REC
Buffers.
Input condition/
Display contents
• For the ETERNUS DX60 S3
0 - 128MB (integral multiple of 8)
• For the ETERNUS DX100 S3/DX200 S3
0 - 512MB (integral multiple of 8)
• For the ETERNUS DX500 S3
0 - 1024MB (integral multiple of 8)
• For the ETERNUS DX600 S3
0 - 4096 (MB) (integral multiple of 8)
• For the ETERNUS DX8700 S3/DX8900 S3
0 - 12288 (MB) (integral multiple of 8)
• For the ETERNUS DX200F
0 - 512MB (integral multiple of 8)
In the ETERNUS DX100 S3, a total size of 512MB of memory is reserved for the copy table and REC Buffer. If an REC
Buffer is created, 256MB (REC Buffer size, 128MB x 2) of the total memory size is used. Therefore, the maximum
table size is 256MB. Note that an REC Buffer cannot be created if the copy table size is larger than 264MB.