Fujitsu Eternus DX600 S3 - Stop Balancing Flexible Tier Pool

Chapter 6 Thin Provisioning Pool Management
6.12 Stop Balancing Flexible Tier Pool
ETERNUS Web GUI User’s Guide (Settings)
Copyright 2015 FUJITSU LIMITED P2X0-1270-13ENZ0
589
6.12 Stop Balancing Flexible Tier Pool
This function stops Flexible Tier Pool (FTRP) balancing sessions.
The procedure to stop balancing FTRP is as follows:
Procedure
1 Select the FTRP for which balancing is to be stopped and click [Stop Balancing FTRP] in
[Action].
 A confirmation screen appears.
2 Click the [OK] button.
 FTRP balancing stops.
3 Click the [Done] button to return to the [Flexible Tier Pool] screen.
End of procedure
• This function cannot be used when no FTRPs are undergoing balancing or when no FTRP balancing that
has stopped due to an error exists.
• This function cannot be used when the specified FTRP balancing is already complete.
If FTRP balancing has stopped, the following conditions apply.
• All of the balancing sessions that are currently being performed (*1) for the FTVs registered in the target
FTRP are stopped. Even when balancing sessions are being stopped, FTVs that are not being balanced can
be accessed normally.
• Note that completed balancing processes for the FTVs in the target FTRP (*1) cannot be stopped (the
physical allocation after the balancing process cannot be changed). FTVs that are balanced can be
accessed normally.
*1: When an FTRP balancing session is started, FTV balancing starts in the FTSPs. Refer to "6.11 Start Balancing
Flexible Tier Pool" (page 587) for details.