Chapter 2 Component Management
2.8 NAS Recovery Management
ETERNUS Web GUI User’s Guide (Settings)
Copyright 2015 FUJITSU LIMITED P2X0-1270-13ENZ0
245
2.8 NAS Recovery Management
This section describes NAS recovery management.
NAS recovery management provides the following functions:
• Force Enable Module
• Recover NAS Engine
• Recover NAS System Volume
2.8.1 Force Enable Module
This function forces the component to be enabled without replacing it (called "force enable" hereinafter).
The procedure to perform force enable is as follows:
1 Select the component to perform the force enable on, and click [Force Enable] in [Action].
A confirmation screen appears.
2 Click the [OK] button.
The force enable starts.
The ETERNUS DX60 S3, the ETERNUS DX8700 S3/DX8900 S3, and the ETERNUS DX200F do not support the
NAS recovery management.
• Force enable can be performed only on one component at a time.
• This function cannot be used when a component whose state is other than " Error" is selected.
This function is available for "NAS-CA" and "NAS Engine".
To Next Page
Loading...
