Appendix A Parameter List
A.6 Thin Provisioning Management
ETERNUS Web GUI User’s Guide (Settings)
Copyright 2015 FUJITSU LIMITED P2X0-1270-13ENZ0
933
• Checkbox to select drives
A.6.5 Modify Threshold Thin Provisioning Pool
For details about this function, refer to "6.8 Modify Threshold Thin Provisioning Pool" (page 580).
For the factory default settings for this function, refer to "Appendix B Modify Threshold Thin Provisioning Pool"
(page 1007).
● Threshold Setting
• Warning
• Attention
Description Select the checkbox for the drive to be selected.
Checkboxes are displayed for unused drives. For 2.5" DEs, drives are displayed from left
to right in ascending order of the slot number. For 3.5" DEs or 3.5" high density DEs,
drives are displayed from bottom left to top right in ascending order of the slot number.
Placing the mouse pointer on the icon displays the detailed information of the drive.
When selecting drives, refer to "Requirements for selecting drives" (page 563)
.
Input condition/
Display contents
Checkbox
• Selected
• Cleared
Description Change the warning threshold (%) for monitoring the TPP used capacity.
Specify the warning threshold so that the "Warning" threshold is the same or larger than
the "Attention" threshold.
Input condition/
Display contents
5 - 99
Description Specify the attention threshold (%) for monitoring the TPP used capacity.
Specify the Attention threshold so that the "Warning" threshold is the same or larger
than the "Attention" threshold.
The "Attention" threshold can be omitted. When setting the "Attention" threshold, select
the checkbox.
Input condition/
Display contents
Checkbox
• Selected
5 - 80
• Cleared
To Next Page
Loading...
