Fujitsu Eternus DX600 S3 - Set DNS Server

Chapter 4 Connectivity Management
4.8 NAS Management
ETERNUS Web GUI User’s Guide (Settings)
Copyright 2015 FUJITSU LIMITED P2X0-1270-13ENZ0
513
2 Enter the name.
The main setting item is as follows.
● NAS Server Settings
• Name
3 Click the [Change] button.
 A confirmation screen appears.
4 Click the [OK] button.
 Changing of the NAS server name starts.
5 Click the [Done] button to return to the [Environment Settings] screen.
End of procedure
4.8.8 Set DNS Server
This function sets the DNS server that is used for the NAS system.
This function is used in a Unified Storage environment.
If the entered name does not satisfy the input conditions, an error screen appears. Check the parame-
ter settings.
• The DNS server settings must be performed before configuring the authentication server.
• When specifying the secondary IP address, the primary IP address settings cannot be omitted.
• When specifying the IPv6 secondary IP address, the IPv6 primary IP address settings cannot be omitted.