Fujitsu Eternus DX600 S3 - Page 165

Chapter 1 System Management
1.10 Audit Log Management
ETERNUS Web GUI User’s Guide (Settings)
Copyright 2015 FUJITSU LIMITED P2X0-1270-13ENZ0
165
2 Specify the parameters.
The main setting items are as follows.
● Syslog Server1, Syslog Server2
• Send Audit Log
• Domain Name / IP Address
• Port No.
• LAN Port
3 Click the [Set] button.
 A confirmation screen appears.
4 Click the [OK] button.
 Setting of the audit log starts.
5 Click the [Done] button to return to the [Audit Log] screen.
End of procedure
If an error screen appears under the following conditions, check the parameter settings.
• When the "Audit Log" setting is "Disable"
• When the specified IP address of the Syslog server conflicts with the internal IP address of the
ETERNUS DX.
Up to two Syslog servers can be configured. When configuring a second Syslog server, specify the
required parameters in "Syslog Server2".