Fujitsu Eternus DX600 S3 - Page 173

Chapter 1 System Management
1.11 Key Management
ETERNUS Web GUI User’s Guide (Settings)
Copyright 2015 FUJITSU LIMITED P2X0-1270-13ENZ0
173
2 Specify the parameters.
The main setting items are as follows.
● Key Group Setting
• Name
• Storage System Group Name
• Security Level
• Recovery Mode
• Key Server
3 Click the [Create] button.
 A confirmation screen appears.
4 Click the [OK] button.
 Key group creation starts.
5 Click the [Done] button to return to the [Key Group] screen.
End of procedure
If an error screen appears under the following conditions, check the parameter settings.
• The "Name" is not entered
• The "Storage System Group Name" is not entered
• Each parameter fails to satisfy the input conditions
• The same server ID is specified for both the master and slave servers