Chapter 4 Connectivity Management
4.2 Host Group Management
ETERNUS Web GUI User’s Guide (Settings)
Copyright 2015 FUJITSU LIMITED P2X0-1270-13ENZ0
417
2 Add a host in the ETERNUS DX in the following procedures.
■ When registering a host by selecting from the host list
(1) Click the [Now Connected] tab.
(2) Select the host that is to be registered from the SAS host list and input the SAS host information.
The main setting items are as follows.
● Host Setting
• Checkbox to select a host
• Name
• Host Response
Filter setting
(3) Click the [Add] button
A confirmation screen appears.
Filter Description
SAS Address
Input the SAS address that is to be displayed.
SAS hosts matching or partially matching the entered SAS address are displayed.
When not using the SAS address for filtering, leave this item blank.
If an error screen appears under the following conditions, check the parameter settings.
• The "Name" is not entered
• The "Name" does not satisfy the input conditions
• The "Name" is already used for the registration target host or the same "Name" is already used in
the ETERNUS DX
• The number of hosts that is to be registered is "0"
• The number of registered hosts has exceeded the maximum number for the ETERNUS DX
To Next Page
Loading...
