Fujitsu Eternus DX600 S3 - Page 46

Chapter 1 System Management
1.4 System Management
ETERNUS Web GUI User’s Guide (Settings)
Copyright 2015 FUJITSU LIMITED P2X0-1270-13ENZ0
46
■ Disabling the SMI-S when the controller firmware version is V10L30 or later (other than the
ETERNUS DX60 S3)
Procedure
1 Click [Setup SMI-S Environment] in [Action].
2 Click the [Stop] button.
 A confirmation screen appears.
3 Click the [OK] button.
 SMI-S setting stops.
4 Click the [Done] button to return to the [System Settings] screen.
End of procedure