Fujitsu Eternus DX600 S3 - Page 479

Chapter 4 Connectivity Management
4.6 Modify CA Reset Group
ETERNUS Web GUI User’s Guide (Settings)
Copyright 2015 FUJITSU LIMITED P2X0-1270-13ENZ0
479
2 Modify the member ports in a CA reset group, and click the [Modify] button.
 A confirmation screen appears.
3 Click the [OK] button.
 Modification of the CA reset group starts.
4 Click the [Done] button to return to the [CA Reset Group] screen.
End of procedure
Checkboxes of the member ports of the specified CA reset group are selected. Select the checkbox of
the port to be added in the corresponding CA reset group. Clear the checkbox of the port to be deleted
from the corresponding CA reset group.
• One port cannot be registered in multiple CA reset groups. If a member port of another CA reset
group has been selected, the member port is deleted from the existing CA reset group.
• If the selected "Port" does not exist, an error screen appears. If this occurs, check the parameter
settings.