Fujitsu Eternus DX600 S3 - Page 483

Chapter 4 Connectivity Management
4.7 Host-LU QoS Management
ETERNUS Web GUI User’s Guide (Settings)
Copyright 2015 FUJITSU LIMITED P2X0-1270-13ENZ0
483
For details on the parameters for this function, refer to "A.4.6.1 Set Host-LU QoS" (page 878).
The procedure to set the Host-LU QoS is as follows:
Procedure
1 Select the "Host - CA Port - LUN Group" to set the Host-LU QoS (multiple selections can be
made) and click [Set Host-LU QoS] in [Action].
2 Click the [Browse...] button in the "LUN Group: LUN QoS Group No." field.
 The [Select LU QoS Group] screen is displayed.
• Before executing the [Set Host-LU QoS] function, configure a bandwidth limit on each host LUN. Refer to
"4.7.14 Add LU QoS Group" (page 499)
for details.
• When checking the number of host LUNs and the bandwidth limit of each LUN in the LU QoS group, refer
to "4.7.16 Modify LU QoS Group" (page 501)
.
• Configure a bandwidth limit on each host. Refer to the following sections for details:
- "4.7.7 Set FC/FCoE Host QoS" (page 489)
- "4.7.8 Set iSCSI Host QoS" (page 490)
- "4.7.9 Set SAS Host QoS" (page 492)
• Configure the CA port bandwidth limit on each CA port. Refer to the following sections for details:
- "4.7.10 Set FC Port QoS" (page 493)
- "4.7.11 Set iSCSI Port QoS" (page 495)
- "4.7.12 Set SAS Port QoS" (page 496)
- "4.7.13 Set FCoE Port QoS" (page 498)