Fujitsu Eternus DX600 S3 - Page 691

Appendix A Parameter List
A.1 System Management
ETERNUS Web GUI User’s Guide (Settings)
Copyright 2015 FUJITSU LIMITED P2X0-1270-13ENZ0
691
● Select Backup Slot
• Configuration Definition Data
A.1.4.2 Start/Stop Performance Monitoring
For details about this function, refer to "1.5.4 Start/Stop Performance Monitoring" (page 69).
For the factory default settings for this function, refer to "Appendix B Start/Stop Performance Monitoring"
(page 975).
● Performance Monitoring (when starting performance monitoring)
• Interval (sec.)
A.1.4.3 Clear Cache
For details about this function, refer to "1.5.5 Clear Cache" (page 71).
For the factory default settings for this function, refer to "Appendix B Clear Cache" (page 975)
.
● Target Cache Settings
• Target Cache
Description Select backup destination of the configuration definition data.
If a backup destination, on which configuration definition data has already been stored,
is selected, the old configuration definition data will be overwritten.
Input condition/
Display contents
• Backup #1
• Backup #2
• Backup #3
• Backup #4
Description Input the interval to acquire the performance information.
Input condition/
Display contents
30 - 300 (units of 30 seconds)
Description Select the cache to clear.
Select the checkbox for the cache that is to be cleared.
Input condition/
Display contents
• "CM" checkbox
- Selected
- Cleared
• "Extreme Cache" checkbox (*1)
- Selected
- Cleared
• "Extreme Cache Pool" checkbox (*2)
- Selected
- Cleared
*1: This item is only displayed when EXC is enabled.
*2: This item is only displayed when EXCP is enabled.