Fujitsu Eternus DX600 S3 - Page 711

Appendix A Parameter List
A.1 System Management
ETERNUS Web GUI User’s Guide (Settings)
Copyright 2015 FUJITSU LIMITED P2X0-1270-13ENZ0
711
• MIB-II RFC Version
A.1.7.4 Setup SNMP Manager
For details about this function, refer to "1.8.4 Setup SNMP Manager" (page 113).
For the factory default settings for this function, refer to "Appendix B Setup SNMP Manager" (page 980)
.
● Manager
• IP Version
• Manager IP Address (IPv4)
• Manager IP Address (IPv6)
Description When enabling the SNMP function, select the MIB-II support RFC version.
Although it is not necessary to change the default setting ("RFC1213") for normal use,
select the RFC version that is supported by the SNMP manager.
Input condition/
Display contents
• RFC1213
This mode is used for MIB-II that supports RFC1213.
This RFC supports IPv4 addresses.
• RFC4293
This mode is used for MIB-II that supports RFC4293.
This RFC supports IPv4 addresses and IPv6 addresses. This RFC is an extended
definition for RFC1213.
Description Specify the IP address of the SNMP Manager.
Input condition/
Display contents
• IPv4
• IPv6
Description Input the IP address of the SNMP Manager with the IPv4 format.
The IP address which has already been used cannot be entered.
This setting is enabled when "IPv4" is selected for "IP Version".
Input condition/
Display contents
xxx.xxx.xxx.xxx
xxx: 1 - 255 for the top field (decimal)
xxx: 0 - 255 for other fields (decimal)
Description Input the IP address of the SNMP Manager with the IPv6 format.
The following IPv6 addresses can be used; "link local address", "global address", "unique
local address", or "6to4 address". Refer to "Available IPv6 Address" (page 107)
for
details.
The IP address which has already been used cannot be entered.
This setting is enabled when "IPv6" is selected for "IP Version".
Input condition/
Display contents
xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx
xxxx: 0 - ffff (FFFF) (hexadecimal, alphanumeric characters)
Refer to "IPv6 Address Notation" (page 378)
for details.