Fujitsu Eternus DX600 S3 - Page 77

Chapter 1 System Management
1.6 Eco-mode Management
ETERNUS Web GUI User’s Guide (Settings)
Copyright 2015 FUJITSU LIMITED P2X0-1270-13ENZ0
77
For details on the parameters for this function, refer to "A.1.5.2 Create Eco-mode Schedule" (page 693).
For the factory default settings for this function, refer to "Appendix B Create Eco-mode Schedule" (page 976)
.
The procedure to create an Eco-mode schedule is as follows:
Procedure
1 Click [Create Schedule] in [Action].
2 Specify the schedule name, and click the [Add Event] button.
• To perform schedule operations using this function, the Eco-mode setting for the ETERNUS DX S3 series
must be enabled.
• Disk operation time varies depending on the Eco-mode schedule settings and disk access. A disk is spun
up even if it is outside of disk operation time in the following conditions:
- If disk access occurs while the disk motor is stopped:
The disk is immediately spun up and can be accessed within 1 - 5 minutes.
- If a disk is activated more than a set amount of times in a day:
A state of increased access frequency is assumed and the Eco-mode will cease stopping the disk
motor.
• To apply the created Eco-mode schedule to each RAID group, refer to the procedure in "5.7 Assign Eco-
mode Schedule (RAID Group)" (page 547).
• To apply the created Eco-mode schedule to each Thin Provisioning Pool, refer to the procedure in "6.10
Assign Eco-mode Schedule (Thin Provisioning Pool)" (page 584).