Fujitsu Eternus DX600 S3 - Page 836

Appendix A Parameter List
A.4 Connectivity Management
ETERNUS Web GUI User’s Guide (Settings)
Copyright 2015 FUJITSU LIMITED P2X0-1270-13ENZ0
836
• Host Response
• IP Version
• IP Address
Description Select a new host response that is to be assigned to the iSCSI host.
The host response list created in the ETERNUS DX is displayed.
This item is available only when an iSCSI host is not registered in the host group.
Input condition/
Display contents
• Solaris MPxIO
• HP-UX
• AIX
• AIX VxVM
• VS850/SVC
• BS2000
• Host responses created in the ETERNUS DX
• Default
Description Select the IP version of the iSCSI host.
Input condition/
Display contents
• IPv4
• IPv6
Description Specify the IP address of the iSCSI host.
There are two methods to specify an IP address; "IPv4" and "IPv6". The IP address must be
specified with the selected IP version (IPv4 or IPv6). The following IPv6 addresses can be
used; "link local address", "global address", "unique local address", or "6to4 address".
Refer to "Available IPv6 Address" (page 107)
for details. When the current setting is
displayed, the IPv6 address is displayed as an abbreviation.
It is not necessary to specify this item if IP address is not used.
Input condition/
Display contents
• For IPv4 address
xxx.xxx.xxx.xxx
xxx: 1 - 255 for the top field (decimal)
xxx: 0 - 255 for other fields (decimal)
• For IPv6 address
xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx
xxxx: 0 - ffff (FFFF) (hexadecimal, alphanumeric characters)
Refer to "IPv6 Address Notation" (page 378)
for details.