Fujitsu Eternus DX600 S3 - Page 899

Appendix A Parameter List
A.4 Connectivity Management
ETERNUS Web GUI User’s Guide (Settings)
Copyright 2015 FUJITSU LIMITED P2X0-1270-13ENZ0
899
• Authentication Server (3)
A.4.7.8 Add Quota Setting
For details about this function, refer to "4.8.10 Add Quota Setting" (page 517).
For the factory default settings for this function, refer to "Appendix B Add Quota Setting" (page 1002)
.
● Select Volume
• Radio button to select a NAS user volume
● Quota Target
• Checkbox to select a quota setting information
● Add Quota Target
• Type
• Name
Description Input the IPv4 address, IPv6 address, or the FQDN of the LDAP authentication server.
Input condition/
Display contents
Up to 255 alphanumeric characters and symbols (in the US-ASCII format)
The following list shows the available characters:
• 0 (0x30) - 9 (0x39)
• A (0x41) - Z (0x5A), a (0x61) - z (0x7A)
• Hyphen (0x2D), period (0x2E), comma (0x3A)
Description Select a quota target NAS user volume.
Input condition/
Display contents
A quota target NAS user volume
Description Select a quota setting information to be deleted.
Only the quota setting information that was added can be deleted. Multiple quota
setting information can be selected at the same time.
Input condition/
Display contents
Checkbox
• Selected
• Cleared
Description Select a type for the quota target.
Input condition/
Display contents
• User
• Group
Description Enter the quota target user name or group name.
Input condition/
Display contents
Up to 255 alphanumeric characters and symbols (0x20 - 0x7E in the US-ASCII format)
(except the question mark (0x3F) and the backslash (0x5C))