Fujitsu Eternus DX600 S3

To Next Page

To Previous Page

Chapter 1 System Management

1.8 Network Management

ETERNUS Web GUI User’s Guide (Settings)

Available port operations for each model

*1: If no other ports are available, this cannot be deleted.

For details on the parameters for this function, refer to "A.1.7.1 Setup Network Environment" (page 703).

For the factory default settings for this function, refer to "Appendix B Setup Network Environment" (page 978)

■ When using IPv4

The procedure to set network environment using IPv4 address is as follows:

Procedure

1 Select which port to set the network environment for, and click [Setup Network

Environment] in [Action].

Model

MNT port RMT port FST port

Setting Modification Deletion Setting Modification Deletion Setting Modification Deletion

ETERNUS

DX60 S3

OK OK OK (*1) OK OK OK (*1) N/A – –

ETERNUS

DX100 S3

OK OK OK (*1) OK OK OK (*1) N/A – –

ETERNUS

DX200 S3

OK OK OK (*1) OK OK OK (*1) N/A – –

ETERNUS

DX500 S3

OK OK OK (*1) OK OK OK (*1) OK OK N/A

ETERNUS

DX600 S3

OK OK OK (*1) OK OK OK (*1) OK OK N/A

ETERNUS

DX8700 S3

OK OK OK (*1) OK OK OK (*1) OK OK N/A

ETERNUS

DX8900 S3

OK OK OK (*1) OK OK OK (*1) OK OK N/A

ETERNUS

DX200F

OK OK OK (*1) OK OK OK (*1) N/A – –

Fujitsu Eternus DX600 S3 - Page 99