Fujitsu ETERNUS LT40 S2 - Figure 3.6 ETERNUS LT40 S2: Slot Numbering Right Magazine; Figure 3.7 ETERNUS LT60 S2: Slot Numbering Right Magazine; Table 3.3 Slot Numbering, Right Magazine

Chapter 3 Operating the Tape Library
3.4 Magazines
FUJITSU Storage ETERNUS LT40 S2/LT60 S2 LTO Library Installing, Starting Up and Maintaining
Copyright 2018 FUJITSU LIMITED P3AM-5392-07ENZ0
49
Figure 3.6 ETERNUS LT40 S2: Slot numbering right magazine
Figure 3.7 ETERNUS LT60 S2: Slot numbering right magazine
Table 3.3 Slot numbering, right magazine
Procedure
1 Unlock the magazines and remove it from the Library
• Use the OCP, see section "5.7 Removing and Replacing a Magazine Using the OCP" (page 92), or
• use the RMU, see section "5.8 Removing and Replacing a Magazine Using the RMU" (page 93)
2 Insert cartridge in the magazines.
3 Put the magazines back to the tape Library. Pull lightly on the magazines to check that they
are locked.
End of procedure
No. Description
25-36 Slot