Fujitsu ETERNUS LT40 S2 - Figure 3.27 ETERNUS LT40 S2: Configuration, SNMP Page

Chapter 3 Operating the Tape Library
3.5 Remote Management Unit (RMU)
FUJITSU Storage ETERNUS LT40 S2/LT60 S2 LTO Library Installing, Starting Up and Maintaining
Copyright 2018 FUJITSU LIMITED P3AM-5392-07ENZ0
62
3.5.6.5 Changing the SNMP Configuration
This page shows the current SNMP configuration of the library and allows modification to the configuration.
When a change is requested, a pop-up box will ask to confirm the changes.
A list of changes that can be made are:
• SNMP Enabled
• IPv4 SNMP Target Addresses
- IPv4 Target 1-3
• IPv6 SNMP Target Addresses
- IPv6 Target 1-3
- Community Name
- Security User Name
- SNMP Trap Notification Filter
Figure 3.27 ETERNUS LT40 S2: Configuration, SNMP page
3.5.6.6 Changing the Administrative Password
This page allows the user to add and modify user accounts.
• Access Level
Choose from 1 (Standard), 2 (Admin), or 3 (Service).
• Access Level Name
the name associated with the chosen Access Level
• New Password
The password can be a maximum of ten characters.
• Repeat Password
Enter the new password again.
• OCP Access Pin Enabled
Select this item, if you would like the Operator Control Panel display to be password protected.
• OCP Access Pin Code
the password for accessing the OCP when the OCP Access Pin is enabled.
• Repeat OCP Access Pin Code
Enter the OCP Access Pin Code again.