Chapter 5 Servicing the Tape Library
5.6 Replacing a Redundant Power Supply
FUJITSU Storage ETERNUS LT40 S2/LT60 S2 LTO Library Installing, Starting Up and Maintaining
Copyright 2018 FUJITSU LIMITED P3AM-5392-07ENZ0
91
■ Replacing the power supply
1 Unpack the new power supply from its package.
2 Slowly insert the new power supply into the bay, and align the connectors on the library
while supporting the power supply assembly.
3 Tighten the captive thumbscrews until the power supply is secure.
4 Replace the power cord cable.
5 Switch on power to the library (power button on the front panel).
5.6 Replacing a Redundant Power Supply
Figure 5.8 Replacing a redundant power supply
1 Loosen the three screws on the library see Figure 5.8, step 1).
2 Unpack the redundant power supply from its package.
3 Slowly insert the new power supply into the bay (see Figure 5.8, step 2),
4 and align the connectors on the library while supporting the power supply assembly.
The second power supply can be installed without powering down the library.
To Next Page
Loading...
