Fujitsu ETERNUS LT40 S2 - Error Code Table; Table 4.4 Error Codes

Chapter 4 Troubleshooting
4.6 Tape Library Error Codes
FUJITSU Storage ETERNUS LT40 S2/LT60 S2 LTO Library Installing, Starting Up and Maintaining
Copyright 2018 FUJITSU LIMITED P3AM-5392-07ENZ0
81
4.6.2 Error Code Table
Table 4.4 Error codes
Error Code Description User Action
80 Barcode Reader Error, cannot initialize BCR Retry operation; after several occurrences contact
technical support
81 Barcode Reader Error, no response from BCR Retry operation; after several occurrences contact
technical support
82 EEPROM Error, no response from EEPROM (located
on robotic controller)
Retry operation; after several occurrences contact
technical support
83 Robotic controller generic problem Reset the unit and retry operation. After several
occurrences contact technical support
84 Setting of gripper motor parameters failed Reset the unit and retry operation. After several
occurrences contact technical support
85 Setting of slider motor parameters failed Reset the unit and retry operation. After several
occurrences contact technical support
86 Setting of elevator motor parameters failed Reset the unit and retry operation. After several
occurrences contact technical support
87 Setting of rotation motor parameters failed Reset the unit and retry operation. After several
occurrences contact technical support
88 Setting of sled motor parameters failed Reset the unit and retry operation. After several
occurrences contact technical support
89 Gripper blocked Run 'Library Health Check', after several
occurrences contact technical support
8A Slider blocked Run 'Library Health Check', after several
occurrences contact technical support
8B Elevator blocked Run 'Library Health Check', after several
occurrences contact technical support
8C Rotation blocked Run 'Library Health Check', after several
occurrences contact technical support
8D Sled blocked Run 'Library Health Check', after several
occurrences contact technical support
8E Cannot find gripper block within the expected
range
Run 'Library Health Check', after several
occurrences contact technical support
8F Cannot find slider block within the expected range Run 'Library Health Check', after several
occurrences contact technical support
90 Cannot find elevator block within the expected
range
Run 'Library Health Check', after several
occurrences contact technical support
91 Cannot find rotation block within the expected
range
Run 'Library Health Check', after several
occurrences contact technical support
92 Cannot find sled block within the expected range Run 'Library Health Check', after several
occurrences contact technical support
93 Gripper outside range, Gripper has reached a
position beyond the expected range
Run 'Library Health Check', after several
occurrences contact technical support
94 Slider outside range, Slider has reached a position
beyond the expected range
Run 'Library Health Check', after several
occurrences contact technical support
95 Elevator outside range, Elevator has reached a
position beyond the expected range
Run 'Library Health Check', after several
occurrences contact technical support