Fujitsu ETERNUS LT40 S2 - Figure 4.3 Remove the Left Magazine; Table 4.3 Removing the Left Magazine

Chapter 4 Troubleshooting
4.4 Magazine Does not Unlock via OCP or RMU
FUJITSU Storage ETERNUS LT40 S2/LT60 S2 LTO Library Installing, Starting Up and Maintaining
Copyright 2018 FUJITSU LIMITED P3AM-5392-07ENZ0
78
3 To manually release the magazines, push the end of a straightened paper clip into the
access hole for each magazine at the back of the library. While holding the paper clip, have
a second person pull the magazine out of the front of the unit. See Figure 4.3
.
Figure 4.3 Remove the left magazine
Table 4.3 Removing the left magazine
End of procedure
If there are additional tapes still in the library, or if you were unable to manually remove the magazines and
drive, contact service for further instructions.
Step Process
1 Insert pin into access hole
2 Release and remove magazine