Fujitsu ETERNUS LT40 S2 - 5.5 Removing and Replacing a Power Supply

Chapter 5 Servicing the Tape Library
5.5 Removing and Replacing a Power Supply
FUJITSU Storage ETERNUS LT40 S2/LT60 S2 LTO Library Installing, Starting Up and Maintaining
Copyright 2018 FUJITSU LIMITED P3AM-5392-07ENZ0
90
5.5 Removing and Replacing a Power Supply
The power supply should only be removed by an experienced service technician.
■ To remove a power supply
Power supply is installed at the back of the library. Before you remove the power supply:
Procedure
1 Turn off power to the library (power button on the front panel).
2 Remove the power cord cable.
3 Loosen the three captive thumbscrews on the power supply (see Figure 5.6).
Figure 5.6 Position of the three thumbscrews
4 Pull straight back on the power supply to remove it from the library (see Figure 5.7).
Figure 5.7 Power supply removal
End of procedure