Chapter 3 Operating the Tape Library
3.5 Remote Management Unit (RMU)
FUJITSU Storage ETERNUS LT40 S2/LT60 S2 LTO Library Installing, Starting Up and Maintaining
Copyright 2018 FUJITSU LIMITED P3AM-5392-07ENZ0
55
3.5.5.3 Viewing the Tape Cartridge Inventory
This page provides detailed information about the tape inventory in the library. A summary of each magazine
is shown. To get detailed information, click on the + button. This will expand the display for the specified
magazine.
Figure 3.14 ETERNUS LT40 S2: Status, Inventory page
3.5.6 Configuration
3.5.6.1 Changing the System Configuration
As changes are made, they will only be applied after the "Apply Selections" (or "Submit") button down right is
selected. To make the changes visible, you have to click the "Refresh" button. After making the selection, a
warning page will inform the user of the impact of their proposed change. In some cases a pop-up screen will
ask the operator to confirm their change. Many changes will also require a reboot.
Changes that can be made are:
• Library Master Drive
• Library Mode: Random, Sequential, Automatic Autoload, Loop
• Active Slots
• Mailslot Enabled
• Auto Clean Enabled
• Barcode Label Length Reported To Host
• Barcode Label Alignment Reported To Host
• Select Language
To Next Page
Loading...
