Feeding Documents Manually
Documents can also be loaded manually one sheet at a time in the ADF paper chute (feeder).
After scanning is started or a document is ejected, the scanner will wait for documents to be loaded in the ADF
paper chute (feeder) until the timeout time elapses.
Scanning will stop if no document is loaded within the timeout time.
By using this method, you can perform scanning as you check the documents one by one.
Manual feeding is effective in the following cases:
● To scan documents as you check the contents of each sheet
● To scan documents that are fed overlapped or jammed when the documents are loaded together in a batch
● To continue scanning documents such as magazines or newspaper clippings that cannot be loaded together, one
at a time
● To scan a document folded in half, an envelope, a multi-layered transfer paper, or a booklet such as a passport
one at a time
1 Configure the settings for the scanner.
● When scanning more than one document manually
a Switch to Manual Continuous Mode and set a timeout time.
- For fi-8190/fi-8290/fi-8170/fi-8270
Use one of the following methods to switch to Manual Continuous Mode, and set a timeout
time.
● Switch to Manual Continuous Mode in [16: Manual/Continuous Feed Setting] on the [Settings
Menu] screen of the operator panel, and specify a timeout time in [17: Manual Feed Timeout].
For details, refer to How to Use Settings Menu (page 146).
● In the Software Operation Panel, switch to Manual Continuous Mode, and set a timeout time.
For details, refer to Waiting Time in Manual Feeding [Manual Feeding] (page 388).
- For fi-8150/fi-8250/fi-8150U/fi-8250U
In the Software Operation Panel, switch to Manual Continuous Mode, and set a timeout time.
For details, refer to Waiting Time in Manual Feeding [Manual Feeding] (page 388).
● When scanning a document folded in half, an envelope, a multi-layered transfer paper, or a booklet such
as a passport manually
a Press the [Manual Feed] button to switch the feed mode to Manual Feed Mode.
ATTENTION
The scanning speed slows down when the feed mode is switched to Manual Feed Mode.
HINT
The setting for switching the feed mode to Manual Feed Mode can also be configured in the
scanner driver.
Various Ways to Scan
202
To Next Page
Loading...
