Fujitsu fi-8190

Situation in Which the Document Is not Fed into the ADF Occurs Frequently
Check the following points
● Do the documents meet the paper requirements? (page 317)
● Did you fan the documents before loading them? (page 317)
● Are the brake roller and pick roller installed correctly? (page 317)
● Are the brake roller and pick roller clean? (page 317)
● Are the brake roller and pick roller worn out? (page 317)
If the problem still persists, check each item in Before You Contact the Scanner Service Provider (page
330) first, then contact the distributor/dealer where you purchased this product. Refer to the contact
information in the Contact List if supplied with this product, or refer to the contact information in the
Contact for Inquiries section if provided in Safety Precautions supplied with this product, and then make an
inquiry.
● Do the documents meet the paper requirements?
Solution
Use documents that meet the requirements.
For details, refer to Documents for Scanning (page 117).
● Did you fan the documents before loading them?
Solution
Fan the documents.
For details, refer to Preparing Documents to Load Them in the ADF Paper Chute (Feeder) (page 111).
● Are the brake roller and pick roller installed correctly?
Solution
Install the brake roller and pick roller correctly.
For details, refer to Replacing the Brake Roller (page 233) and Replacing the Pick Roller (page 238).
● Are the brake roller and pick roller clean?
Solution
Clean the brake roller and pick roller.
For details, refer to Daily Care (page 214).
● Are the brake roller and pick roller worn out?
Solution
Check the counters for the brake roller and pick roller.
● For fi-8190/fi-8290/fi-8170/fi-8270
Check the counters for the brake roller and pick roller with one of the following methods.
Troubleshooting
317