Fujitsu fi-8190

Specifying the Sensitivity Level for Paper Protection [Paper Protection
Sensitivity]
Specify the sensitivity level for detecting feeding errors when the paper protection function is enabled.
Documents are skewed abnormally or paper jam noise is made when documents are not being fed properly.
Specify the sensitivity level to detect an abnormal document skew or paper jam noise.
ATTENTION
fi-8190/fi-8290/fi-8170/fi-8270 is supported to detect paper jam noise.
1 Start up the Software Operation Panel.
For details, refer to Starting Up the Software Operation Panel (page 333).
2 From the list on the left, select [Device Setting 2] → [Paper Protection Sensitivity].
3 Select the sensitivity level.
● For fi-8190/fi-8290/fi-8170/fi-8270
- Select the sensitivity level to detect [Feeding Skew].
Normal
Detects an abnormal document skew with the optimum sensitivity.
This is the factory default setting.
High
Increases the sensitivity level to detect an abnormal document skew.
Specify this to detect an abnormal document skew even if there is a slight skew in the document.
HINT
To detect an abnormal document skew immediately and stop the scan, select [High].
- Select the sensitivity level to detect [Feeding Noise].
Low
Decreases the sensitivity level to detect paper jam noise.
Specify this to detect only loud paper jam noise.
Normal
Detects paper jam noise with the optimum sensitivity level.
This is the factory default setting.
High
Increases the sensitivity level to detect paper jam noise.
Specify this to detect even slight paper jam noise.
Scanner Settings (Software Operation Panel)
371