Setting to Ignore Certain Overlap Patterns [Intelligent Multifeed Function]
Configure the setting to automatically ignore certain patterns of overlapped documents when the setting to detect
overlapped documents is enabled.
Note that you first need to specify [Check Overlapping(Ultrasonic)] or [Check Overlapping and Length] in the
scanner driver and Specifying a Method to Detect Overlapped Documents [Multifeed] (page 378) on the Software
Operation Panel before setting this item.
1 Start up Software Operation Panel.
For details, refer to Starting Up the Software Operation Panel (page 333).
2 From the list on the left, select [Device Setting 2] → [Intelligent Multifeed Function].
3 Select an operation mode.
Standard mode
Specify whether overlapped documents are detected when re-scanning documents detected as
overlapped documents.
Does not memorize the size or location of the paper attachment.
Overlapping is not detected for a piece of paper (80 mm or less in the feeding direction) attached on a
document (such as sticky notes).
Scanning will stop immediately if overlapped documents are detected.
Note that if the setting for stopping the scan to check images is set to on in the scanner driver, scanning
will stop after overlapped documents are ejected.
This is the factory default setting.
Manual mode
Specify whether overlapped documents are detected when re-scanning documents detected as
overlapped documents.
Does not memorize the size or location of the paper attachment.
Scanning will stop immediately if overlapped documents are detected.
Note that if the setting for stopping the scan to check images is set to on in the scanner driver, scanning
will stop after overlapped documents are ejected.
Auto mode 1
Specify whether the length and position of a piece of paper attached on a document detected as
overlapped documents are memorized as an overlap pattern.
If the overlap pattern is memorized, documents with the same overlap pattern are not detected as
overlapped documents from the next scan.
Scanning will stop after the overlapped documents are ejected.
In this operation mode, up to four overlap patterns can be memorized at a time (when one sheet is
scanned), and up to 32 overlap patterns can be memorized in total.
When the 33rd overlap pattern is detected, the first pattern that was memorized is overwritten.
However, when turning the scanner off and on, the number of memorized overlap patterns depends on
the setting for [Remember overlap patterns at power-off] in the Software Operation Panel.
For details, refer to Setting to Ignore Certain Overlap Patterns [Intelligent Multifeed Function] (page
386).
Scanner Settings (Software Operation Panel)
386
To Next Page
Loading...
