Fujitsu fi-8190

● For fi-8190/fi-8290/fi-8170/fi-8270
Check the counters for the brake roller and pick roller with one of the following methods.
- Check the counters for the brake roller and pick roller in [5:Consumable counters] on the [Settings
Menu] screen of the operator panel.
For details, refer to How to Use Settings Menu (page 146).
- Check the counters for the brake roller and pick roller in the Software Operation Panel.
For details, refer to Checking the Sheet Counters (page 352).
● For fi-8150/fi-8250/fi-8150U/fi-8250U
Check the counters for the brake roller and pick roller in the Software Operation Panel.
For details, refer to Checking the Sheet Counters (page 352).
If necessary, replace the brake roller and pick roller.
For details, refer to Replacing the Brake Roller (page 233) and Replacing the Pick Roller (page 238).
● Is the sensitivity level for the paper protection function set to high?
Solution
Lower the paper protection sensitivity level.
● For fi-8190/fi-8290/fi-8170/fi-8270
Use one of the following methods to lower the paper protection sensitivity level.
- Select [1: Normal] for [Skew Sensitivity] and [1: Low] for [Sensitivity for feeding noise] in [18: Paper
Protection] on the [Settings Menu] screen of the operator panel.
For details, refer to How to Use Settings Menu (page 146).
- Select [Normal] for [Feeding Skew] and [Low] for [Feeding Noise] in the Software Operation Panel.
For details, refer to Specifying the Sensitivity Level for Paper Protection [Paper Protection Sensitivity]
(page 371).
● For fi-8150/fi-8250/fi-8150U/fi-8250U
Select [Normal] for [Feeding Skew] in the Software Operation Panel.
For details, refer to Specifying the Sensitivity Level for Paper Protection [Paper Protection Sensitivity]
(page 371).
Troubleshooting
320