Fujitsu M10 User Manual

Caution -
When attaching or removing the door, be careful not to catch your finger,
etc. in the gap between the door and rack. The notch for the front door hinge has a
bend for controlling the opening and closing angle, so you may find it difficult to
slide the door
laterally.
䋨㪋䋩
䋨㪈䋩
䋨㪉䋩
䋨㪊䋩
FRONT
Number in
figure
Description
1 Hinge on door
2Notch for hinge
3Bend for controlling opening and closing angle
4 Hinge on main body
1.
Confirm that the connecting kit supplied with expansion rack 2 is complete.
2.
Remove the front doors of expansion racks 1 and 2.
a. Open the door about 90°.
b. Lifting up the door, remove the hinge (pin) on the main body of the rack.
Then, slide the door laterally to remove
it.
Figure 3-17
Removing the front door
3.
Remove the rear doors of expansion racks 1 and 2.
a. Open the door about 90°.
b. Lifting up the door, remove the hinge (pin) on the main body of the rack.
Then, slide the door laterally to remove it.
4.
Remove the screws securing the
top cover of expansion rack 1, and remove
the side plate.
a. Use an Allen wrench to remove the two M12 screws securing the top cover, at
the front and rear on the right side, which is the connecting side. The removed
screws will not be used.
Chapter 3 Installing the System 89

Fujitsu M10 Specifications

General

Brand	Fujitsu
Model	M10
Category	Server
Language	English