Fujitsu M10 - Page 140

Note -
After removing or loosening the screw or screws, hold the rail level with both hands.
If the rail tilts, it may stretch.
A
A
B
FRONTFRONT
FRONTFRONT
C
FRONTFRONTFRONTFRONT
BB
Note -
After removing its screw, hold the rail level with both hands. If the rail tilts, it may
stretch.
Figure 3-70
Screw on the side of the Type-1 rail
Figure 3-71
Screws on the side of the Type-2 rail
5.
Attach the rail to the rack.
- For the Type-1 rail
Fujitsu M10/SPARC M10 Systems Installation Guide
･
July 2015126