Fujitsu M10 - Page 178

A
A
A
Figure 5-1
Serial port location on the XSCF unit
2.
Connect a LAN cable of Category 5 or higher from a GbE port (A in Figure 5-2)
to the network switch or hub.
The GbE ports are used for the user network. Connect the other servers, other
PCs, UPS, etc. that are
necessary for business via the network switch or hub.
Figure 5-2
GbE port locations
3.
If a PCIe card is mounted, connect a LAN cable and I/O cable to the respective
ports on the PCIe card.
4.
Connect the supplied power cords to the power supply units (A in Figure 5-3).
Secure the
power cords with a power clamp.
Figure 5-3
Power supply unit locations
Fujitsu M10/SPARC M10 Systems Installation Guide
･
July 2015164