Fujitsu M10 - Page 194

Service
Locked
Note -
The operation panel of the SPARC M10-4 does not have the area enclosed by the
dashed line.
Service
Locked
Figure 6-2
Mode switch on the operation panel of the SPARC M10-4/SPARC
M10-4S
Figure 6-3
Mode switch on the operation panel of a crossbar box
2.
Confirm that the power cord connector is connected to a power supply unit of
the chassis.
3.
Connect the power cord plug to an outlet.
a. If the
outlet has a circuit breaker, turn on the circuit breaker switch.
Fujitsu M10/SPARC M10 Systems Installation Guide
･
July 2015180