Fujitsu M10 - Page 238

*Note*
This

command

only

issues

the

instruction

to

power-on.
The

result

of

the

instruction

can

be

checked

by

the

"showpparprogress".
Note -
In the SPARC M10-1, a physical partition takes about 5 minutes to start. In the SPARC
M10-4, it takes about 7 minutes. In the SPARC M10-4S in the 4BB configuration, it takes
about 25 minutes.
Note -
Oracle Solaris does not start automatically because the auto-boot? setting is false.
XSCF>

showpparprogress

-p

0
PPAR

Power

On

Preprocessing

PPAR#0

[

1/12]
PPAR

Power

On

PPAR#0

[

2/12]
XBBOX

Reset

PPAR#0

[

3/12]
PSU

On

PPAR#0

[

4/12]
CMU

Reset

Start

PPAR#0

[

5/12]
XB

Reset

1

PPAR#0

[

6/12]
XB

Reset

2

PPAR#0

[

7/12]
XB

Reset

3

PPAR#0

[

8/12]
CPU

Reset

1

PPAR#0

[

9/12]
CPU

Reset

2

PPAR#0

[10/12]
Reset

released

PPAR#0

[11/12]
CPU

Start

PPAR#0

[12/12]
The

sequence

of

power

control

is

completed .
XSCF>
XSCF#

showdomainstatus

-p

0

Logical

Domain

Name

Status

primary

OpenBoot

Running

XSCF#

3.
Execute the showpp arprogress command.
You can check the progress, in the midst of processing, between physical
partition power-on and up to before the start of POST.
Confirm that the command displays "The sequence of power control is
completed." and ends.
4.
Execute the showdo mainstatus command, and confirm that statu s is
"OpenBoot Running".
5.
Execute the console command to connect to the console of the specified
physical partition.
The auto-boot? setting is false, so you can confirm the start up to the ok prompt.
Fujitsu M10/SPARC M10 Systems Installation Guide
･
July 2015224