Fujitsu M10 User Manual

Remarks -
The product model number of a chassis in which SPARC64 X+ processors are
mounted begins with "SPMCG". Check the model indication on the label affixed on the
upper right of the front cover or check the system nameplate on the right side surface of the
chassis.
Table 8-2
Relationship between the CPU configuration and firmware update
CPU configuration of the
physical partition before
addition
CPU configuration
of the chassis to be
added
XCP firmware/Oracle Solaris
SPARC64 XSPARC64 X+ Update to versions supporting SPARC64 X+ is
required beforehand. (*1)
SPARC64 X+ SPARC64 X+ Update is not required beforehand. (*2)
SPARC64 X+ and X
mixed
SPARC64 X+ Update is not required beforehand. (*2)
SPARC64 X+ SPARC64 X Update is not required beforehand. (*2)
chassis) to the 8BB configuration changes the master chassis from the SPARC
M10-4S to a crossbar box mounted in an expansion rack. The existing SPARC
M10-4S must be released from the system before installation of the expansion rack.
Multiple SPARC M10-4S units cannot be released at the same time. Do this
work
on one unit at a time.
■
Any installation that changes the 8BB configuration to the 9BB configuration or
larger requires the new installation of expansion rack 2. For details of expansion
racks, see "2.4 Confirming Rack Specifications."
■
Any installation that changes the 8BB configuration to the 9BB configuration or
larger requires special attention because crossbar cables need to be laid all over
again.
■
Executing the addfru command for installation automatically updates firmware to
match firmware versions. The update matches the version on the master XSCF, so
we recommend updating XCP on the master XSCF to the latest version in advance.
■
Suppose you install the SPARC M10-4S together with a PCI expansion unit
connected to it and set the enabling/disabling setting of the direct I/O function of
the PCI expansion unit. In this case, execute the setpciboxdio command to set the
enabling/disabling setting before installing it on the physical partition by
executing
the addboard command. Set the setting. When you have changed the
setting of the direct I/O function, do not restart the logical domains until you
execute the ldm add-spconfig command to save the logical domain configuration
in XSCF.
■
When installing a SPARC M10-4S on which SPARC64 X+ processors are mounted
in a system in which only SPARC64 X processors are mounted, update the XCP
firmware and Oracle Solaris beforehand.
For details, see "A.5 For Expansion of the System Board Configured by SPARC64
X+ Processor to the Physical Partition Configured
Only by the SPARC64 X
Processor" in the Fujitsu M10/SPARC M10 Systems Domain Configuration Guide.
Fujitsu M10/SPARC M10 Systems Installation Guide
･
July 2015230

Fujitsu M10 Specifications

General

Brand	Fujitsu
Model	M10
Category	Server
Language	English