Fujitsu M10 - Page 259

Maintenance/Addition

Menu
Please

select

the

chassis

including

added

FRU.
No.

FRU

Status
---

-------------------

--------------

1

/BB#0

Normal

2

/BB#1

Normal

3

/BB#2

Unmount

4

/BB#3

Unmount
------------------------------------------------------------------------------
Select

[1,2|c:cancel]

:
c
XSCF>

testsb

-v

-p

-s

-y

XX-Y
XSCF>

testsb

-v

-p

-s

-y

01-0
Initial

diagnosis

is

about

to

start,

Continue?[y|n]

:y

SB#01-0

power

on

sequence

started.

XSCF>

diagxbu

-y

-b

xx

-p

yy
4.
Diagnose the inst alled SPARC M10-4S.
a.
Execute the testsb command to perfor m a diagnosis test.
Specify the PSB number of the diagnosis target PSB in XX-Y. XX is a BB-ID,
and Y is fixed at 0.
An initial diagnosis and connection I/O check are performed on the diagnosis
target PSB.
<Description of options specified>
-v: Additionally displays detailed messages of the initial diagnosis
-p: Executes the "probe-scsi-all" command of OpenBoot PROM and displays
the results while a diagnosis is being processed
-s: Executes the "show-devs" command of OpenBoot PROM and displays the
results while a diagnosis is being processed
-y: Automatically
responds with "y" to a query
The following example performs a diagnosis test on the installed BB#01.
If an error is displayed, see "A.2.4 Checking diagnosis results."
b.
From the master XSCF, check the cables between the installed chassis and
the physical partition that is the incorporation destinatio n.
Execute the
diagxbu command to check the cables.
Specify the BB-ID of the installed BB in XX. Specify the PPAR-ID of the
incorporation destination in YY.
The following example performs a diagnosis between the installed BB#01 and
incorporation-destination PPAR#0.
Chapter 9 Installing a System with a Building Block Configuration 245