Fujitsu M10 User Manual

XSCF>

setpcl

-p

0

-a

01=01-0
XSCF>

showpcl

-p

0
PPAR-ID

LSB

PSB

Status
00

Running

00

00-0

01

01-0
XSCF>

showcodusage

-p

resource
Resource

In

Use

Installed

CoD

Permitted

Status
--------

------

---------

-------------

------
PROC

64

64

128

OK:

64

cores

available
Note -
If the number of registered CPU Activation keys is insufficient for the number of CPU
cores to be used, request the customer to purchase CPU Activations to add CPU Activation
keys. For details on adding a CPU Activation key, see "7.11.3 Registering a CPU Activation
key."
XSCF>

showcod

-p

0
PROC

Permits

assigned

for

PPAR

0:

64
XSCF>

setcod

-p

0

-s

cpu

128
Execute the setpcl command to register the system board of the installed
SPARC M10-4S in the physical partition configuration list for the incorporation
destination.
The following example associates physical system board (PSB) 01-0 with
logical system board (LSB) 01 of physical partition 0.
c.
Execute the show pcl command, and confirm the set physical partition
conf iguration list.
8.
Register a CPU Activation key, and assign CPU core resources.
a.
Execute the showcodusage command to display the
CPU Activation key
information.
The following example displays the CPU Activation key information.
b.
Execute the showcod command to check the CPU resource information for
the physical partition.
c.
If the assigned resources are insufficient, execute the setcod command to
assign CPU resources to the physical partition.
The following example assigns 128 CPU core resources to the physical partition.
d.
If you have assigned CPU resources, execute the showcod command
Chapter 9 Installing a System with a Building Block Configuration 247

Fujitsu M10 Specifications

General

Brand	Fujitsu
Model	M10
Category	Server
Language	English