Fujitsu M10 - Page 272

XSCF>

showcod

-p

0
PROC

Permits

assigned

for

PPAR

0:

64
XSCF>

setcod

-p

0

-s

cpu

128
XSCF>

showcod

-p

0
PROC

Permits

assigned

for

PPAR

0:

128
XSCF>

console

-p

0
#

ldm

list-domain
NAME

STATE

FLAGS

CONS

VCPU

MEMORY

UTIL

UPTIME
primary

active

-n-cv-

UART

32

28G

0.0%

2h

3m
guest0

active

-n----

5100

64

64G

3.1%

33m
root-dom0

active

-n--v-

5000

32

32G

3.1%

47m
Note -
Suppose you install the installed SPARC M10-4S together with a PCI expansion unit
c.
If the assigned resources are insufficient, execute the setcod command to
assign CPU resources to the physical partition.
The following example assigns 128 CPU core resources to the physical partition.
d.
If you have assigned CPU resources, execute the showcod command
again to check the information on the CPU resources assigned to the
physical partition.
11.
Check the operation status of logical domains.
a.
Connect to the control domain console of the physical partition, and then
log in.
b.
Execute the ldm list-domain
command to check the operation status of the
logical domains.
Check the operation status of the logical domains through the combination of
[STATE] and [FLAGS]. When [STATE] is "active," the second character from
the left of the string in [FLAGS] has one of the following meanings:
"n": Oracle Solaris operating
"t": OpenBoot PROM state
"-": Another state (including cases in which STATE is not active)
In the following example, you can see that the control domain, one guest
domain, and one root domain are operating.
12.
Incorporate the system board of the installed SPARC M10-4S into the physical
partition.
Fujitsu M10/SPARC M10 Systems Installation Guide
･
July 2015258