Fujitsu M10 User Manual

co
n
n
ected to it and set the e
n
abli
n
g
/
disabli
n
g setti
n
g of t
h
e direct I
/
O function of the PCI
expansion unit. In this case, execute the setpciboxdio command to set the enabling/disabling
setting before installing it on the physical partition by executing the addboard command.
When you have changed the setting of the direct I/O function, do not restart the logical
domains until you execute the ldm
add-spconfig command to save the logical domain
configuration in XSCF.
Note -
Pull out all the PCIe cassettes with the PCIe card for the PCI expansion unit to be
installed. After incorporating the link card into the server, attach the pulled-out PCIe cassette
to the PCI expansion unit. Then, install the PCIe
card of the PCI expansion unit on the server
by using PHP.
XSCF>

showboards

-p

0
PSB

PPAR-ID(LSB)

Assignment

Pwr

Conn

Conf

Test

Fault
----

------------

-----------

----

----

----

-------

--------
00-0

00(00)

Assigned

n

n

n

Passed

Normal

01-0

00(01)

Assigned

n

n

n

Passed

Normal
02-0

SP

Available

n

n

n

Passed

Normal
XSCF>

addboard

-c

assign

-p

0

02-0
PSB#02-0

will

be

assigned

into

PPAR-ID

0.

Continue?[y|n]

:
y
XSCF>

showresult
0
XSCF>

showboards

-p

0
PSB

PPAR-ID(LSB)

Assignment

Pwr

Conn

Conf

Test

Fault
----

------------

-----------

----

----

----

-------

--------
00-0

00(00)

Assigned

n

n

n

Passed

Normal

01-0

00(01)

Assigned

n

n

n

Passed

Normal
02-0

00(02)

Assigned

n

n

n

Passed

Normal
a.
Return to the XSCF shell, execute the show boards command, and check
the system board (PSB) status.
In the following example, system board 02-0 is in the system board pool.
b.
Execute the addboard command to assign the system board (PSB).
The following example assigns system board 02-0 to physical partition
0.
c.
Execute the showre sult command to confirm the end statu s of the
previously executed addboard command.
In the following example, 0 is returned as the end status, so the execution of
the addboard command has completed correctly.
d.
Execute the showbo ards command to check the system board (PSB)
statu s , and confirm
that the system board (PSB) has been added.
13.
Start the physical partition.
The following example starts PPAR#0.
Chapter 9 Installing a System with a Building Block Configuration 259

Fujitsu M10 Specifications

General

Brand	Fujitsu
Model	M10
Category	Server
Language	English