Fujitsu M10 User Manual

Note -
The device serial of either the master XSCF or standb y XSCF is used as the representative
device serial. If the device serial of the standby XSCF is being used as the representative
device serial, the initbb command cannot release the standby chassis. In this case, execute the
switchscf command to switch the master XSCF.
XSCF>

poweroff

-y

-a
PPAR-IDs

to

power

off:00,01,02

03
Continue?

[y|n]:y
00:Powering

off
01:Powering

off
02:Powering

off
03:Powering

off
connections.
To move the SPARC M10-4S to an expansion rack, stop the entire system and then
perform the work.
Note the following points on this work.
■
All the system setting information will be cleared and reset to the factory defaults.
Before removing the SPARC M10-4S, save the system setting information with the
dumpconfig command. In case of resetting the configuration to the original
setting, you can restore the saved setting information to XSCF by using the
restoreconfig
command.
■
Multiple SPARC M10-4S units cannot be released from the system by using the
initbb command at the same time.
■
The serial number of the chassis of either the master XSCF or standby XSCF is
used as the system serial number. If the serial number of the standby chassis is
being used as the system serial number, the initbb command cannot release the
standby chassis. In this case, execute the switchscf
command to switch the master
XSCF.
■
For the initialization of the chassis of the master XSCF, perform that work at the
end.
Execute the restoredefaults -c factory command to return to the factory defaults,
including the CPU Activation key information. Perform this work with a serial
connection to the master XSCF.
For XCP 2041 or later, execute the restoredefaults -c factory -r activation command.
The key must be reinstalled at initial setup of the XSCF after installation.
1.
Log in to the mast er XSCF.
2.
Execute the showhardconf command, and confirm the chassis serial number
of the system board (PSB) targeted for release.
For details, see "A.2.1 Checking the component status."
3.
Execute the poweroff command to
stop all the physical partitions.
4.
Execute the deleteboard command from the mast er XSCF to release a system
board (PSB) from the physical partition configuration.
The following example releases system boards 00-0, 01-0, 02-0, and 03-0 from the
Fujitsu M10/SPARC M10 Systems Installation Guide
･
July 2015266

Fujitsu M10 Specifications

General

Brand	Fujitsu
Model	M10
Category	Server
Language	English