Fujitsu M10 User Manual

XSCF>

deleteboard

-c

unassign

00-0

01-0

02-0

03-0
PSB#00-0

will

be

unassigned

from

PPAR

immediately.

Continue?[y|n]

:
y
PSB#01-0

will

be

unassigned

from

PPAR

immediately.

Continue?[y|n]

:
y
PSB#02-0

will

be

unassigned

from

PPAR

immediately.

Continue?[y|n]

:
y
PSB#03-0

will

be

unassigned

from

PPAR

immediately.

Continue?[y|n]

:
y
XSCF>

showresult
0
XSCF>

showboards

-a
PSB

PPAR-ID(LSB)

Assignment

Pwr

Conn

Conf

Test

Fault
----

------------

-----------

----

----

----

-------

--------
00-0

SP

Available

n

n

n

Passed

Normal
01-0

SP

Available

n

n

n

Passed

Normal
02-0

SP

Available

n

n

n

Passed

Normal
03-0

SP

Available

n

n

n

Passed

Normal
XSCF>

initbb

-b

bb_id
XSCF>

initbb

-b

3
You

are

about

to

initializ e

BB/XB-Box.
NOTE

the

following.
1.

BB/XB-Box

is

excluded

from

the

system

and

halted.
2.

PPAR-ID

of

the

same

value

as

BB-ID

becomes

invalid.
Continue?

[y|n]

:
y
Note -
After the execution of the initbb command, the target chassis is released from the
system and enters the stopped state. Do not disconnect the power cords or various cables
until the XSCF STANDBY LED on the panel and the rear READY LED of the target chassis
are off.
physical partition.
5.
Execute the showre sult command, and confirm the end statu s of the
previously executed deleteboard command.
In the following example, 0 is returned as the end status, so the execution of the
deleteboard command has completed correctly.
6.
Execute the show boards command to check the system board (PSB) statu s.
In the
following example, system boards 00-0, 01-0, 02-0, and 03-0 are in the
system board pool.
7.
Execute the initbb command from the master XSCF to release the target
SPARC M10-4S from the system and initialize it.
In bb_id, specify the ID (BB-ID) identifying the chassis.
The following example releases BB#03 from the system
and initializes it.
Chapter 9 Installing a System with a Building Block Configuration 267

Fujitsu M10 Specifications

General

Brand	Fujitsu
Model	M10
Category	Server
Language	English