Fujitsu M10 User Manual

XSCF>

showbbstatus
BB#00

(Master)
Note -
If the serial number of the target chassis is being used as the system serial number, the
initbb command cannot release the chassis. In this case, execute the switchscf command to
switch the master XSCF.
XSCF>

poweroff

-y

-a
PPAR-IDs

to

power

off:00,01,02,03
Continue?

[y|n]:
y
00:Powering

off
01:Powering

off
02:Powering

off
03:Powering

off
XSCF>

deleteboard

-c

unassign

00-0

01-0

02-0

03-0
PSB#00-0

will

be

unassigned

from

PPAR

immediately.

Continue?[y|n]

:
y
PSB#01-0

will

be

unassigned

from

PPAR

immediately.

Continue?[y|n]

:
y
PSB#02-0

will

be

unassigned

from

PPAR

immediately.

Continue?[y|n]

:
y
PSB#03-0

will

be

unassigned

from

PPAR

immediately.

Continue?[y|n]

:
y
XSCF>

showresult
0
2.
Execute the show hardconf command, and confirm the chassis serial number
of the system board (PSB) targeted for release.
For details, see "A.2.1 Checking the component status."
3.
Execute the poweroff command to stop all the physical partitions.
4.
Execute the deleteboard command from the master XSCF to release a system
board (PSB)
from the physical partition configuration.
The following example releases system boards 00-0, 01-0, 02-0, and 03-0 from the
physical partition.
5.
Execute the showre sult command, and confirm the end statu s of the
previously executed deleteboard command.
In the following example, 0 is returned as the end status, so the execution of the
deleteboard command has completed correctly.
6.
Execute the show boards command to check the system board (PSB) statu s.
In the following example, system boards 00-0, 01-0, 02-0, and 03-0 are in the
system board pool.
Chapter 10 Removing a System with a Building Block Configuration 291

Fujitsu M10 Specifications

General

Brand	Fujitsu
Model	M10
Category	Server
Language	English