Fujitsu M10 User Manual

XSCF>

initbb

-b

bb_id
XSCF>

initbb

-b

1
You

are

about

to

initialize

BB/XB-Box.
NOTE

the

following .
1.

BB/XB-Box

is

excluded

from

the

system

and

halted.
2.

PPAR-ID

of

the

same

value

as

BB-ID

becomes

invalid.
Continue?

[y|n]

:
y
Note -
After the execution of the initbb command, the target chassis is released from the
system and enters the stopped state. Do not disconnect the power cords or various cables
until the XSCF STANDBY LED on the panel and the rear READY LED of the target chassis
are off.
The following example releases BB#01 from the system and initializes it.
9.
Remove the power cords from the power supply units of the target SPARC
M10-4S.
10.
Remove the XSCF BB control cables from the target SPARC M10-4S.
11.
Remove the crossbar cables from the target SPARC M10-4S.
12.
You are performing removal to the
1BB configuration. So, remove the XSCF
DUAL control cable.
13.
Remove the target SPARC M10-4S from the rack.
Remove the SPARC M10-4S from the rack by reversing the mounting procedure.
For the procedure for mounting in the rack, see "3.4.2 Mounting the SPARC
M10-4/SPARC M10-4S in a rack."
10.2.3 Removing the server after stopping all the physical
partitions (PPARs)
This section describes the SPARC M10-4S removal procedure after stopping all the
physical partitions (PPARs). To change all SPARC M10-4Ss to a 1BB configuration as
shown in pattern B (2) in Figure 8-3, stop all the physical partitions and then perform
removal.
For details on the XSCF commands executed in
each step, see the Fujitsu M10/SPARC
M10 Systems XSCF Reference Manual.
1.
Log in to the mast er XSCF.
Execute the showbbstatus command to confirm that the XSCF to which you have
logged in is the master XSCF.
If it is a standby XSCF, retry to log in to the master XSCF.
Fujitsu M10/SPARC M10 Systems Installation Guide
･
July 2015290

Fujitsu M10 Specifications

General

Brand	Fujitsu
Model	M10
Category	Server
Language	English