Fujitsu M10 - Page 373

Table C-1
XSCF setup command examples (continued)
XSCF command example Description Mandatory? Linked section
showcod -v -s cpu Checks the number of assigned CPU
Activations
Yes "7.12 Assigning CPU Core
Resources"
Starting and stopping a physical partition
setpparparam -p 0 -s
bootscript "setenv
auto-boot? false"
Changes the setting of auto-boot?,
which is an OpenBoot PROM
environment variable
Yes "7.13 Starting and Stopping a
Physical Partition (PPAR)"
poweron -a Starts a physical
partition Yes "7.13 Starting and Stopping a
Physical Partition (PPAR)"
showpparprogress -p 0 Displays the physical partition status
Example: The progress between
PPAR-ID 0 power-on and the start of
POST is displayed in the midst of
processing.
Yes "7.13 Starting and Stopping a
Physical Partition (PPAR)"
showdomainstatus -p 0 Displays the logical domain status
Example: The
status of all logical
domains on PPAR-ID 0 is displayed.
Yes "7.13 Starting and Stopping a
Physical Partition (PPAR)"
console -p 0 Connects to the control domain
console of a physical partition (PPAR)
Yes "7.13 Starting and Stopping a
Physical Partition (PPAR)"
poweroff -a Stops a physical partition Yes "7.13 Starting and Stopping a
Physical Partition
(PPAR)"
showpparprogress -p 0 Displays the physical partition status Yes "7.13 Starting and Stopping a
Physical Partition (PPAR)"
*1 If you execute the setdate command after setting the altitude, you can skip rebootxscf because the XSCF is automatically reset after the
command is executed.
Appendix C Setup Command Workflow 359